Control your MPH
Using a Master controller to control your fixture series offers you maximum control, ease of use, plug and play installation and safety. Connect the control cables to the fixture, set the dials on the fixtures to EXT (External Control), connect the controller and the fixtures directly to the mains and you're ready to go.
Full lighting control at your fingertips
The controller can turn all interconnected fixtures on and off with its internal timer, adjust them to your desired output level (in percentage or exact output power) and even simulate sunrise and sunset to gradually adjust the climate in your growroom when your lights are on or off. This electronic controller replaces expensive lighting timers and switches and at the same time prevents
the ballast current when the lighting is switched on.
Two very important features are the autodim function and the emergency shutdown. When the temperature in your growroom rises above the control level of your climate control system, your crop may be damaged if it is not repaired. The temperature probe senses this and will automatically dim. If, for any reason, your climate control fails completely and the temperature rises to an unacceptable level, the system will perform an emergency shutdown resulting in all connected equipment being shut down. The controller's alarm contact can be connected to your alarm system for immediate notification.
You can connect all your e-Series MPH fixtures to one controller, even divided into 2 separate rooms with their own temperature sensor for auto-dimming at high temperature and emergency shutdown at extreme temperature.
For auxiliary equipment, you can connect up to two EEM contactor modules, one for switching equipment when the lights are on (e.g. humidifier, CO2 equipment or air conditioning) and one for when the lights are off (e.g. a room heater).
Spectro Light MPH Controller - Manual